Alfa Romeo 164 Register.com

Well boys I did not wait for answers of course.
There is no way other on a 3.0L V6 in order to take down the starter:
plenum
exhaust pipe
starter hot shield
exhaust tube
middle gear shaft

Lot of work to come but it gives pleasure when finished.
Thanks for the pictures.

Hello. Just a post to help anyone having a fuel pressure problem. I had this on my 3L V6 with idling and accelaration uncorrect. I put a manometer on fuel injection entry fiding only 1 bar. I changed the pressure damper, nothing better, then I changed the pump, took off and cleaned the injectors, va...

Welcome Mathieu.

Hello,
well done, it seems to be a beautyfull alfa red 164 Twin Spark.
Thanks.

Hello,
salve, Ho vissuto a lungo vicino al confine ei genitori di mia moglie sono di origine italiana.
Sono stato più volte al museo di Arese.
Welcome and tell us what do you need.

Please help !
What is the right way to take off and replace the starter unit on 164 3L V6 1988 ?
Thanks

Replace the electrical motor behind the needle soldering neg or plus is out.

Hi, Did you check if the fuel pump receives electricity? Also I believe the fuel pump starts working only when cranking the engine. If the fuel pump does not get any electricity you could check the relay in the engine bay. Hi thanks it was the starter having overheat I knocked it now it works but t...

Hi, I took off the fuel pump and found water and aluminium filings in the bottom of the tank :shock: Now its been cleaned but after some starting and engine stalling, :mrgreen: I CAN'T START THE ENGINE ............. :evil: THE DASHBOARD LIGHTS ON BUT WHEN I TURN ON THE KEY NOTHING HAPPENS AT ALL.......

Alfan wrote: ↑

Fri Dec 10, 2021 9:45 pm

I hope you found the explanation to this. I have no idea what would be the solution when removing the ABS pump...

Santa's bringing a 20.6 mm new brake pump
I'll tell after installataion

Thanks
I had already bought this

https://www.ebay.com/itm/173826333964

Well me again and my 164 3.0 L
does anyone knows why when I turn the steering wheel on the left side driving at low speed or making a half-turn, the engine has misfires or something like injection or fuel arrival fails.

And if this can help someone: I had several no engine start with my wife's 156 1.8 TS in early 2021. These were due to irregular ethanol proportions (E85) mixed to 98 or 95 RON gasoline and my fault because I wanted to use 85. REsults were warning lights on instruments and lots of default MIL. The o...

Hi guys, I noticed that the download link for the 164 diagnostics software is broken/unavailable. http://alfaromeo164register.com/diagnostics/index.php I'd like to download the software to help me to diagnose the ABS warning light on my 24v Cloverleaf. If anyone can provide it, or if the download l...

HI
I'm looking for OEM 60611308 FUEL PRESSURE VALVE for my 3.0L.
Seems to be hard to find and expansive.
Someone has an offer to make ??

Hello, I have started up a 3.0 L V6 sleeping 14 years long. Absolutely all consomables pieces have been changed. Very smart to drive but it has one small problem: the engine start fine, good idle run, it accelerates strongly till 3000 rpm and seems to snort untill 4000 rpm then runs to red zone with...

Alfan wrote: ↑

Thu Oct 21, 2021 6:47 am

What do you mean by that, are you using another ABS pump?

Photos of the pumps would be good

no ABS pump is off the car
I red that if ABS is off I have to take of the brake pump and replace by one with a smaller diameter :: 20.6 in place of 22.2
Could it be right ??????????

hi,
on the road few days ago with my 3.0 L
it's a great strong and very smooth and comfortable 164

maybe I found the reason:
supress the ABS means replace the 22mm pump for a smaller diameter 20.6

Absolutely impossible to have pression in brake sytem although all is new, pump, callipers, hoses, pads,......
There are NO bubbles at callipers only brake fluid very clean.
I don't understand what happens.
Does anyone has an idea.

Today I begin to renew a 164 3L V6 in the way to use it soon. I bought it 2 years ago and just start the engine one time per week. Engine first: https://i.postimg.cc/CZB68Qt8/P1020545.jpg https://i.postimg.cc/mtZ49TSF/P1020548.jpg Everything is going to be done in time thanks to my worker https://i....

ALFAHEIDA wrote: ↑

Mon Aug 30, 2021 8:14 pm

www.tuynder.nl

Thanks, I do not know this seller I have a look.

obenhaus wrote: ↑

Mon Aug 30, 2021 4:42 am

https://victorparts.com/fr/

Yes I know them, a bit expensive.

Thank you, you're great .
I found it there are only 2 items