Alfa Romeo 164 Register.com

yea, only one of the 2, i would leave it in.. but both of those jobs.. just lower the subframe with engine.. the subframe needs to loose anyway to remove the gearbox and that is a bitch.. so yea, lower the wole thing..

My Q4 does just over 10 km/l on long distances. short and cold.. maybe 6 km/l

Good to hear

i think it was also used on a fiat or lancia if i remember right...

although it's 30 degrees + now, i managed to take a snow picture

Yes!
long distance Norwegian roads (up down left right all the time) 1:10
short distance to work 1:5

you where talking about the trottle.. check your trottle position sensor. and also the connection to it. if faulty. the 4WD light comes up but it's still engaged.

the airbag ecu is in the mid console close to the engine ecu.
You can check the yellow cable under the dashboard passenger side going up to the airbag itself.. maybe someone did "bridge" it so it's not in use with a little kid on the frontseat.. just a wild guess.. but since its shortcut...

@Arjen.. You might have a failty trottle angle sensor.. i think i once mentioned a toyota one with same number in alternative parts. was pretty cheat aswel..

that would have been my first guess.. sucking air.. that make a Q4 jumpy especialy when cold..

the question about shielded or not. The speed of the protocol is only 4800 baud. which is pretty slow.
I have seen original testers with 3 meters unshielded wire so i guess it should go just fine.

Yeah that's what I have tried.
Light on the connector is on.
Green and Red lights in program on but turns off then I try to connect and the yellow light starts flashing.

The green light is not on, until I have pressed connect, so it seems you have different behaviour...

Wilco....?
the yellow ...

Hi there all..
I'm sorry for not beeing around so much.. i'll try to be more around.. so ask :D

the new type airbag is the allied signal airbag. at some point i will also integrate this one into the program and i did start it, but due to lack of time.. i just didn't finish it..
what you can do ...

i have it on both the Q4 and the 24V (squeeking sound) .. Only when harder braking.. i just learned to life with it..

ok that's nice to read.. nothing really serious then..

nice one. always welcome

I think it will be worth it to ask.. maybe we have to make a poll on who is interested to buy one..

wheelbearing?

but still... 95 degrees is not that bad... it takes time to reach the radiator where the fan thermoswitch sits Try give it some more rpm on idle and see if the temparature drops.. i still think the waterpump does not pump enough on idle to keep it lower on temp..

well.. the yellow light shows the connection request.
the green lights on received data
The red lights on sending data.
So it might the ecu is not responding.
Also set the buffers and responsetime for the port as low as possible.
What hardware do you use ? (PC)

very nice project. thumbs up also for your english. easy to follow

Looks very nice

haha well.. i'm not so sure if i like it to be the winner

it was sliding a bit too much whehehe..
It is a lot in a short time yea.. they talk about rain tomorow.. i don't believe that